![]() ![]() In conclusion, if your deadbolt is not unlocking it could be due to a variety of reasons. If this is the case, then you should contact a professional locksmith who can help diagnose and fix any underlying issues. If lubrication does not help, then disassembling and cleaning out the lock may be necessary.įinally, if your deadbolt is an electronic one, then it could be having an issue with its power source or internal wiring. However, keep in mind that if too much lubricant is applied, it could end up making things worse instead of better. If this is the case, then applying some lubricant (such as WD-40) to the bolt may help to loosen it. This can require specific tools and knowledge, so it might be best to call a professional locksmith if you don’t have experience with this type of work.Īnother possible cause is that the bolt itself has become stuck in the locked position. To address this issue, you will need to disassemble the lock and either replace or repair the pins. If any of these pins are damaged or worn down, the key won’t be able to turn and unlock the door. The pins are tiny metal pieces which interact with the key to unlock the door. It could be due to a number of factors, but the good news is that there are a few things you can try before calling a locksmith.įirst, the most likely cause is a problem with the pins inside the lock. If your deadbolt is not unlocking, it can be frustrating and confusing. However, if none of these solutions work then it may be time to contact a professional locksmith who can diagnose and repair any complex issues with your lock system. You can find these replacement keypads in many hardware stores or online retailers such as Amazon.īy following these steps, you should be able to get your Kwikset keypad lighting up again. Kwikset offers a wide range of replacement keypads that are easy to install and use. If none of the above solutions work, then it may be time to replace the keypad altogether. This should reset the keypad and allow it to power up again. Try resetting the keypad by pressing and holding down the “lock” button for at least five seconds. If the power source is connected properly and the batteries are still good, then it is possible that the keypad itself may be malfunctioning. ![]() Make sure that the power source is securely plugged into an outlet with no loose connections. If the keypad is still not lighting up, check to make sure that the power source is connected properly. If not, replace the batteries and see if that helps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |